TM 11-6625-3081-23
5-6. BASE ASSEMBLY REPAIR (cont)
5-6
(23) Check that tubing is secured
by retaining clamps where
removed.
(24) Refer to 2a above and
perform steps 33 thru 39.
(25) Refer to 1 above and install
protective skirts.
(26) Refer to paragraph 5-7 and
adjust base assembly.
END OF TASK
c. To replace isolator number 3,
proceed as follows:
REMOVAL
(1) Refer to 1 above and remove
front, rear, and left side
protective skirts.
(2) On left side of base remove
four screws (1), lockwashers
(2), washers (3), and two
protective cups (4).
(3) Remove two studs (5) from
base assembly (6).
NOTE
Transport retainers on right side of
base must be in operational mode.
(4) Remove six screws (7),
washers (8), and remove two
transport retainer
brackets (9).
5-22
