TM 11-6625-3081-23
5-6. BASE ASSEMBLY REPAIR (cont)
5-6
NOTE
Transport retainers should be placed
in operational position with flat of
washer against bracket.
(37) Install two transport
retainer brackets (9) with
six screws (7) and washers
(8).
Torque screws (7) to
50 ft-lb.
(38) Install two studs (5) into
base assembly (6).
(39) Install two protective cups
(4) with four screws (1),
lockwashers (2), and
washers (3).
(40) Refer to 1 above and install
protective skirts.
(41) Refer to paragraph 5-7 and
adjust base assembly.
END OF TASK
b. To replace isolator number 2,
proceed as follows:
REMOVAL
(1) Refer to 2a above and
perform steps 1 thru 9.
(2) On isolator (1), tag and
disconnect yellow tube (2)
from tee fitting (3) and two
natural tubes (4) from oppo-
site tee fitting (5).
(3) Tag and disconnect yellow
tube (6) from isolator
fitting (7).
5-18
