TM 11-6625-3081-23
6-4. MAJOR TEST ADAPTER REPAIR (cont)
6-4
6. SWITCH S2 OR S4 REPLACEMENT
NOTE
This procedure is used to replace
switch S2 or S4.
REMOVAL
a.
Rotate three turnlock fasteners
(1) counterclockwise and open the
circuit card cover assembly (2).
b.
Remove two screws (3), washers
(4), spacers (5), lockwashers
(6), and nuts (7).
c.
Tag and unsolder wires from two
contacts (8), and remove
defective switch (9).
INSTALLATION
d.
Install in reverse order of
removal.
END OF TASK
7. FILTER ASSEMBLY REPLACEMENT
REMOVAL
a.
Slide filter assembly (1) out
from the bottom of the major test
adapter (2).
b.
Inspect filter for defects and
cleanness.
Refer to paragraph
2-22 for cleaning.
INSTALLATION
c.
Install in reverse order of
removal.
END OF TASK
6-7
