TM 11-6625-3081-23
6-4. MAJOR TEST ADAPTER REPAIR (cont)
6-4
3. CONNECTORS J5 THROUGH J12
REPLACEMENT
NOTE
This procedure is used to replace any
of connectors J5 through J12.
REMOVAL
a.
b.
c.
d.
Remove six screws (1) and washers
(2), and remove rear access cover
(3).
Holding rear of connector (4),
remove nut (5) and lockwasher
(6).
Pull connector (4) out of major
test adapter (7) and remove
shield (8).
Unsolder contact (9) and remove
connector.
INSTALLATION
e.
Install in reverse order of
removal.
END OF TASK
4. CONNECTOR J13 REPLACEMENT
REMOVAL
a.
b.
c.
d.
Remove six screws (1) and washers
(2), and remove rear access cover
(3).
Holding rear of connector (4),
remove nut (5) and lockwasher
(6).
Pull connector out of major test
adapter (7) and remove nut and
wire (8).
Remove connector.
6-5
