TM 11-6625-3081-23
5-6. BASE ASSEMBLY REPAIR (cont)
5-6
END OF
5-38
ISOPROPYL ALCOHOL
FLAMMABLE, TOXIC, IRRITATING. CAN
CAUSE BREATHING PROBLEMS, EYE
DAMAGE.
DON’T:
USE NEAR FLAMES OR SPARKS,
LET IT GET IN EYES, OR BREATHE
VAPORS.
DO:
USE IN WELL-VENTILATED AREA,
CLOSE CONTAINERS WHEN NOT USING.
WEAR ACID-TYPE SAFETY GOGGLES.
IF IT CONTACTS EYES, WASH EYES
WITH RUNNING WATER. GET MEDICAL
HELP AT ONCE.
IF YOU EXPERIENCE ANY BREATHING
PROBLEMS, GET TO FRESH AIR AT
ONCE.
(10) Clean screws (11) and mating
holes in isolator with
isopropyl alcohol.
(11) Apply sealing compound
primer to threads, allow
to dry.
(12) Apply sealing compound to
threads of screws (11).
Install valve assembly (10)
with four screws (11).
Torque screws (11) to
14 ft-lb.
(13) Refer to diagram below and
attach two blue tubes (12)
to tee fitting (4) and
natural tube (13) to oppo-
site fitting (5).
Finger
tighten only.
(14) Refer to 2C above and do
steps 32 thru 38.
(15) Refer to 1 above and install
protective skirts.
(16) Refer to paragraph 5-7 and
adjust base assembly.
TASK
