TM 11-6625-3081-23
5-6.
BASE ASSEMBLY REPAIR (cont)
5-6
ISOPROPYL ALCOHOL
FLAMMABLE, TOXIC, IRRITATING. CAN
CAUSE BREATHING PROBLEMS, EYE
DAMAGE.
DONT:
USE NEAR FLAMES OR SPARKS,
LET IT GET IN EYES, OR BREATHE
VAPORS.
DO:
USE IN WELL-VENTILATED AREA,
CLOSE CONTAINERS WHEN NOT USING.
WEAR ACID-TYPE SAFETY GOGGLES.
IF IT CONTACTS EYES, WASH EYES
WITH RUNNING WATER. GET MEDICAL
HELP AT ONCE.
IF YOU EXPERIENCE ANY BREATHING
PROBLEMS, GET TO FRESH AIR AT
ONCE.
(12) Clean screws (8) and mating
holes on isolator (1) with
isopropyl alcohol.
(13) Apply sealing compound
primer to threads, allow
to dry.
(14) Apply sealing compound to
threads of screws (8).
Install valve assembly (15)
with four screws (8).
Torque screws (8) to
14 ft-lb.
(15) Refer to diagram and attach
two natural tubes (4) to tee
fitting (5) on isolator (1).
Finger tighten only.
(16) Attach orange tube (2) to
tee fitting (3) on isolator.
Finger tighten only.
(17) Attach orange tube (6) to
isolator fitting (7).
Finger tighten only.
(18) Refer to 2a above and
perform steps 32 thru 39.
5-33
