ISOPLEXER OFFSET AND GAIN ADJUSTMENT (SLOT J6) (Cont)

ISOPLEXER OFFSET AND GAIN ADJUSTMENT (SLOT J6)

ISOPLEXER OFFSET AND GAIN ADJUSTMENT (SLOT J6) (cont) - TM-11-6625-3081-23-5_253

TM-11-6625-3081-23-5 Electronic Equipment Test Facility TADS/PNVS Augmentation Equipment Manual
Page Navigation
218

TM 11-6625-3081-23 8-3. ANALOG TO DIGITAL CONVERTER ASSEMBLY 2A2A13 (cont) 8 - 3 85. 86. 87. 88. 89. 90. 91. 92. 93. 94. 95. 96. If necessary, adjust R101 (36) until front panel DATA DISPLAY indicates as close to O as possible. (Upper limit is 4 and lower limit is 177774.) Remove shorting plug from P1 of rf cable assembly. Connect P1 of rf cable assembly to unconnected connector of 13081706-69 cable. If necessary, adjust R105 (37) until front panel DATA DISPLAY indicates as close to 60000 as possible. (Upper limit is 60004 and lower limit is 57774.) Remove P1 of rf cable assembly from 13081706-69 cable. Set front panel digiswitches to 100250. Install shorting plug on P2 of rf cable assembly. Press front panel ANALOG switch. If necessary, adjust R201 (38) until front panel DATA DISPLAY indicates as close to O as possible. (Upper limit is 4 and lower limit is 177774.) Remove shorting plug from P2 of rf cable assembly. Connect P2 of rf cable assembly to unconnected connector of 13081706-69 cable. If necessary, adjust R205 (39) until front panel DATA DISPLAY indicates as close to 60000 as possible. (Upper limit is 60004 and lower limit is 57774.) Remove P2 of rf cable assembly from 13081706-69 cable. Set front panel digiswitches to 100260. 8-14 Change 8

Privacy Statement
Press Release
Contact