TM 11-6625-3081-23
5-6. BASE ASSEMBLY REPAIR (cont)
5-6
(36) Install two transport
retainer brackets (9) with
six screws (7) and washers
(8).
Torque screws (7) to
50 ft-lb.
(37) Install two studs (5) into
base assembly (6).
(38) Install two protective cups
(4) with four screws (1),
lockwashers (2), and
washers (3).
(39) Refer to 1 above and install
protective skirts.
(40) Refer to paragraph 5-7 and
adjust base assembly.
END OF TASK
d. To replace isolator number 4,
proceed as follows:
REMOVAL
(1) Refer to 2C above and
perform steps 1 thru 9.
(2) On isolator (1), disconnect
blue tube (2) from fitting
(3).
(3) Remove piston plate (4) from
isolator (1).
(4) Mark a line around bottom of
isolator (1). Replacement
isolator must be installed
in same position.
(5) Remove two bolts (5), lock-
washers (6), and isolator
(1).
(6) Remove fitting (3) from
isolator and clean teflon
tape residue from threads.
5-28
