TM 11-6625-3081-23
HARNESS ASSEMBLY REPAIR (cont)
5-27
5-27.
7.
CONNECTOR J6 REPLACEMENT
REMOVAL
a. Remove CCA A14.
b.
Disconnect connector P6 (2) from
connector J6 (3) by loosening two
screwlocks (1).
c.
Remove bracket with connector J6
(3) from chassis assembly by
removing two screws (4) and
washers (5).
d.
Remove connector J6 (3) from
bracket by removing two nuts (6),
lockwashers (7), and washers
(8).
e. Remove connector J6 (3) from
wiring harness.
INSTALLATION
f.
Install connector J6 (3) on
wiring harness.
g.
Install connector J6 (3) on
bracket using two washers (8),
lockwashers (7), and nuts (6).
h.
Install connector J6 (3) in
chassis assembly using two screws
(4) and washers (5).
i.
Connect connector P6 (2) to
connector J6 (3) and tighten two
screwlocks (1).
j.
Install CCA A14.
END OF TASK
Change 9
5-122.5/(5-122.6 blank)
