TM 11-6625-3081-23
5-13.1 HOD M0UNTING BRACKET ASSEMBLY 2A1A1A4 REPAIR (cont)
5-13.1
w.
Solder three leads to target
wheel sensor assembly (10) as
identified on wiring diagram.
x.
Using lacing tape, spot tie leads
as required to form neat cable
harness.
y.
Apply zinc chromate primer to
threads of four screws (12).
z. Install motor guard (11) and four
screws (12).
ISOPROPYL ALCOHOL
FLAMMABLE, TOXIC, IRRITATING. CAN
CAUSE BREATHING PROBLEMS, EYE
DAMAGE.
DON’T:
USE NEAR FLAMES OR SPARKS,
LET IT GET IN EYES, OR BREATHE
VAPORS.
DO:
USE IN WELL-VENTILATED AREA,
CLOSE CONTAINERS ’WHEN NOT USING.
WEAR ACID-TYPE SAFETY GOGGLES,
RUBBER GLOVES, AND RUBBER APRON.
IF IT CONTACTS EYES, WASH EYES
WITH RUNNING WATER. GET MEDICAL
HELP AT ONCE.
IF YOU EXPERIENCE ANY BREATHING
PROBLEMS, GET TO FRESH AIR AT
ONCE.
aa. Clean contacts of connector P1
and target wheel sensor assembly
using isopropyl alcohol and blow
dry thoroughly.
END OF TASK
5-66.6
Change 3
