TM 11-6625-3081-23
5-13.1 HOD MOUNTING BRACKET ASSEMBLY 2A1A1A4 REPAIR (cont)
5-13.
INSTALLATION
j.
Obtain three 3-inch and three
12-inch wire leads.
Strip ends
of all leads.
k.
Cut off connector supplied with
replacement stepper motor
assembly.
l.
Cut back insulation sleeving and
strip ends of all leads from
stepper motor assembly except the
encoder green lead.
m.
Refer to the wiring diagram and
splice a 3-inch lead to CTP1, a
3-inch and a 12-inch lead to
CTP2, and a 3-inch and a 12-inch
lead to CTP3.
n.
Tin one end of each 12-inch lead.
o.
Insulate unused (green) lead by
shrinking a l-inch piece of
insulation tubing over free end.
p.
Fold back green lead and slide
cable marker over leads of
stepper motor assembly.
q.
Crimp replacement contact on 10
leads from stepper motor assembly
and untinned lead of remaining
12-inch lead.
r.
Install 11 contacts in connector
P1 according to the wiring
diagram.
5-66.4
