TM 11-6625-3081-23
2-17. OPERATOR INSTRUCTION MESSAGES (cont)
2-17
(25) NOTE:
DIGITIZER ADJUSTMENTS
WOULD BE MADE WITHIN THE 2% LIMITS,
ADJUSTMENTS WITHIN THE 5% LIMITS WILL PASS
THE ALIGNMENT.
PRESS YES <F5> TO MAKE GAIN ADJUSTMENT
TO THE LEFT CHANNEL.
PRESS NO <F6> TO END ALIGNMENTS.
If the measured voltage is higher than
the 2% upper limit value or lower than
the 2% lower limit value, press <YES>
and perform the adjustment.
If you
are unable to adjust the voltage
within the 2% limits after several
attempts but it is within the 5% upper
and lower limit values, press <NO>.
If you cannot adjust the voltage
within the 5% upper and lower limit
values, press <NO>.
(26) LEFT CHANNEL GAIN ADJUSTMENT:
TO INCREASE GAIN ADJUST FRONT PANEL
GAIN POT (14) CLOCKWISE.
TO DECREASE GAIN ADJUST FRONT PANEL
GAIN POT (14) COUNTERCLOCKWISE.
PRESS <PROCEED> FOR NEXT READING.
When you press <PROCEED>, test program
loops back to step (23), displays the
new gain value, and waits for you to
press <YES> to make another adjustment
or <NO> to end the channel A
measurement.
RIGHT CHANNEL GAIN ADJUSTMENT
(27) READING CHANNEL B
Test program determines the gain value
for channel B input A.
Change 9
2-142.19
