TM 11-6625-3081-23
2-17.
OPERATOR INSTRUCTION MESSAGES (cont)
2-17
an. FIRALIGN MESSAGES
INSTALL MAJOR TEST ADAPTER 13083633-19 IN
TEST ADAPTER PANEL ASSEMBLY A2A4J1 AND
CLOSE LOCKING LEVER.
VERIFY THAT NO PERSONALITY CARDS ARE
INSERTED IN MAJOR TEST ADAPTER CONNECTORS
45, A6, A7, A8, A9.
Refer to paragraph 2-65 for installation
procedures.
HIGH VOLTAGE
OPEN DOOR ON AH-64A TEST SET DC
POWER STATION A2 CABINET AND PLACE
‘UUT PWR’ CIRCUIT BREAKER ON AC
CONTROL PANEL A2A11 TO ‘OFF’.
FAILURE TO REMOVE UUT POWER WILL
CONSTITUTE A SHOCK HAZARD AND MAY
CAUSE EQUIPMENT DAMAGE.
DO NOT PLACE THIS CIRCUIT BREAKER
TO ‘ON’ UNTIL INSTRUCTED TO DO SO.
WHEN COMPLETE, CLOSE CABINET DOOR ON DC
POWER STATION AND PRESS <PROCEED>.
CONNECT P1 OF CABLE 13082730 TO MAJOR
TEST ADAPTER J4 (1).
CONNECT P2 OF CABLE 13082730 TO TEST
ADAPTER PANEL ASSEMBLY A2A4J6 (2).
CONNECT P5 OF CABLE 13082730 TO UUT
STATION DIU A4J1 (3).
CONNECT P6 OF CABLE 13082730 TO UUT
STATION DIU A4J2 (4).
CONNECT P7 OF CABLE 13082730 TO UUT
STATION DIU A4J9 (5).
CONNECT P3 OF CABLE 13082730 TO UUT
STATION DIU A4J26 (6).
CONNECT P9 OF CABLE 13082730 TO UUT
STATION DIUA4J29 (7).
CONNECT P1O OF CABLE 13082730 TO UUT
STATION DIU A4J30 (8).
CONNECT P4 OF CABLE 13082730 TO UUT
STATION DIUA4J32 (9).
CONNECT P11 OF CABLE 13082730 TO UUT
STATION DIU A4J34 (10?.
CONNECT P12 OF CABLE 13082730 TO UUT
STATION DIU A4J36 (11).
Change 9)
2-142.23
