TM 11-6625-3081-23
5-6. BASE ASSEMBLY REPAIR (Cont)
5-6
4. TUBING REPLACEMENT
a.
Refer to 1 above and remove
protective skirts as needed to
NOTE
access tubing assemblies.
This procedure contains instructions
to replace any tubing used in the
base assembly.
REMOVAL
PNEUMATIC SYSTEM PRESSURE MUST BE
BLED DOWN BEFORE PERFORMINGMAINTE-
NANCE ON BASE ASSEMBLY TO AVOID
INJURING PERSONNEL OR DAMAGING
EQUIPMENT.
b.
If jacking of base is required to
access tubing on right side,
refer to 2a above and do steps 2
thru 9.
If access to tubing on
left side is required, refer to
2C above and do steps 2 thru 9.
5-39