TM 11-6625-3081-23
7-9. CABLE ASSEMBLY (TARGET LAMP) 2A1A2A11W19
7 -9
INPUT CODE: DCDCTL
a. DESCRIPTION
This module tests the ability of cable assembly (target lamp) 2A1A2A11W19 to
respond to on and off commands.
The target lamp is programmed on and shutter
assembly 2A1A2A2 opens.
The operator observes the lamp by looking through the open
shutter and if lamp is on, presses [YES] or if lamp is off, presses [NO] on the
AN/USM-410 VDT.
If NO is pressed, a prompt is displayed at the completion of the test.
The target lamp is then programmed off.
The operator observes the lamp through
the open shutter and if lamp is on, presses [YES] or if lamp is off, presses [NO] on
the AN/USM-410 VDT.
If YES is pressed, a prompt is displayed.
b. REPLACEMENT PROCEDURE REFERENCE
The following list provides a cross reference of replacement items to
replacement procedures.
The item column identifies the item to be replaced by
reference designation and part number.
The reference column identifies the
procedural paragraph used to perform the replacement action. The VDT screen will
display the proper sequence of repair/replace actions.
Item
Reference
(Ref Des/Part No.)
(Para No.)
2A1/13082800-59
5-9
2A2A4A1K9/13083063
5-33
2A1A2A11W19/13082266 (LAMP)
5-21
2A2A6XX (SLOT 409)/69331B
2-49
2A2A7A4K5/13081572
2-34
7-45
