CAPACITOR REPLACEMENT

TM-11-6625-3081-23-4 Electronic Equipment Test Facility TADS/PNVS Augmentation Equipment Manual
Page Navigation
8

TM 11-6625-3081-23 4-5. BLOWER ASSEMBLY 1A6 0R 1A12 REPAIR (cont) 4-5 b. Use shorting probe and short out each capacitor terminal to ground. c. Loosen nut (5). d. Rotate capacitor bracket (6), loosen screw (7), and lift out capacitor. e. Tag and remove three wires (8) from capacitor terminals. INSTALLATION f. Install capacitor in reverse order of removal. END OF TASK BLOWER MOTOR REPLACEMENT NOTE This procedure is used to replace the blower motor contained in blower assembly 1A6 (1) or 1A12 (1). REMOVAL a. Refer to paragraph 1 above and do steps a and b. b. Remove two retaining rings (4) from each grill (5) and lift out grill. c. On rear of blower assembly (1), remove 11 screws (2) and eight screws (3). 4-9

Privacy Statement
Press Release
Contact