TM 11-6625-3081-23
5-38. HEAT SOURCE TARGET ASSEMBLY 2A3A1A1 REPAIR (cont)
5-38
7.
OPTICAL SWITCH/CABLE ASSEMBLY W20
REPLACEMENT
REMOVAL
a.
Refer to 1 above and do steps a
through h to gain access to
optical switch.
b.
Cut lacing tape as required to
remove optical switch/cable
assembly (1).
c.
Disconnect connector W20J1 from
connector W6P7 (2).
CAUTION
Exercise special care when working
near optical surfaces.
Avoid touch-
ing or contaminating any optical
surface.
d.
Remove two screws (3), washers
(4), and optical switch/cable
assembly (1).
INSTALLATION
e.
Install in reverse order of
removal.
END OF TASK
5-180
