TM 11-6625-3081-23
5-38. HEAT SOURCE TARGET ASSEMBLY 2A3A1A1 REPAIR (cont)
5-39
5. MOTOR/CABLE ASSEMBLY W16
REPLACEMENT
REMOVAL
a.
Refer to 1 above and do steps a
through g to gain access to
motor.
b.
On motor/cable assembly (1),
disconnect W16J1 from W6P8 (2).
CAUTION
Exercise special care when working
near optical surfaces.
Avoid touch-
ing or contaminating any optical
surface.
c.
Loosen setscrew (3) on clutch
hub (4).
d.
Remove three screws (5) and motor
mount assembly (6).
e.
On clamp (7), loosen screw (8)
and remove clamp.
f.
Remove two screws (9), and remove
motor/cable assembly (1).
INSTALLATION
g.
Install in reverse order of
removal.
END OF TASK
5-178