TM 11-6625-3081-23
5-32. OPTICAL SIGNAL GENERATOR (OSG) ASSEMBLY 2A2A3 REPAIR (cont)
5-32
3. LAMP SENSOR A2 REPLACEMENT
REMOVAL
a.
Remove OSG covers (1 above).
b.
Remove lacing and tying tape from
connector P4 (1) and disconnect.
c.
Remove four socket head capscrews
(2) and washers (3).
d.
Remove light shield (4) with
sensor assembly (5) from OSG.
e.
Remove two screws (6), washers
(7), sensor assembly (5),
lockwashers (8), and nuts (9)
from light shield.
INSTALLATION
NOTE
Washers are used on both sides of
sensor assembly.
f.
Install sensor assembly (5) with
two screws (6), washers (7),
lockwashers (8), and nuts (9).
g.
Install light shield assembly (4)
with four socket head capscrews
(2) and washers (3).
h.
Connect sensor assembly connector
(1) to W1P4 and secure with
lacing and tying tape.
i.
Install OSG covers (1 above).
END OF TASK
5-140
Change 6