TM 11-6625-3081-23
2-58. SWITCH CONTROLLER ASSEMBLY 2A2A12 REPLACEMENT
2-58
INITIAL SETUP
Personnel Required
Tools
39B ATE Repairer
Goggles
Equipment Condition
Rubber apron
Power removed (para 2-24.1)
Materials (appendix C)
Artist brush (Item 8)
Cheesecloth pad (Item 11)
Chemical film (Item 12)
Rubber gloves (Item 26)
Emery paper, 400 grit (Item 35)
Zinc chromate primer (Item 40)
Trichlorotrifluoroethane (Item 48)
REMOVAL
1.
2.
3.
Remove four screws (1)3 lockwashers
(2), washers (3), and pull out switch
controller assembly (4).
Remove screw (5) and protective
plate (6).
On rear panel of switch controller
assembly, disconnect the following
cables:
HP 09412-61604 P1 from SWITCH
CONTROL (7)
HP 09412-61603 P1 from J3 MAIN
POWER (8)
HP 10833B P2 from HP-IB (9)
HP 10833C P1 from HP-IB (10)
115 vac power cord (11)
Change 2
2-297
