TM 11-6625-3081-23
2-12. GENERAL (cont)
2-12
b. SELF-TEST DESCRIPTION (cont)
MAIN MENU
SELF-TEST MENU
1) E/O BENCH SELF-TEST MODE
1) ALL TESTS MODE
2) E/O BENCH ALIGNMENT MODE
2) SINGLE TEST MODE
99) EXIT PROGRAM
3) PRINT EQUIPMENT LIST
99) RETURN TO MAIN MENU
ENTER CHOICE:
ENTER CHOICE:
Single self-test may be used to run a specific procedure for check out, trouble-
shooting or after a repair has been made.
There are three single self-test menus.
These menus are selected by system software depending on E/O bench configuration and
site activity.
The menus are based on the following criteria:
OSA delete panel installed
OSA installed and AVIM test site
OSA installed and depot test site
Single self-test should not be used unless modules CALCST, PLLBUS, MTRXSW, ADST,
and DIGITST have been performed successfully. The three single
shown below.
IVD contains all the procedures included in IVDST
installed), plus the code necessary for checking cable 13083701
panel internal wiring.
self-test menus are
(with OSA
and the OSA delete
Single self-test menu with OSA delete panel installed.
SINGLE SELF-TEST MENU
1)
2)
3)
4)
5)
6)
7)
8)
CALCST
PLLBUS
MTRXSW
ADST
DIGITST
FPSST
PPSST
PPGTST
9) VSGST
17)
10) FIRCSST
18)
11) FIRCTGST
19)
12) FIRCAST
20)
13) DCDCS
21)
14) DCDCTL
22)
15) EXTRAD
23)
16) DCAMIR
24)
DCBMIR
25) LASERST
DCINTCAM
26) FIXTST
DCEXSO
27) IVD
DCFOCUS
28) AUGTEM
DCVARF
29) BITCHECK
DCEXTCAM
30) VIDEOST
INTRAD
99) RETURN
OSGST
ENTER CHOICE:
Change 16
2-62.1
