TM 11-6625-3081-23
2-54. MATRIX SWITCH ASSEMBLY 2A2A1O REPLACEMENT (cont)
2-54
2.
On matrix switch assembly (5), remove
four nuts (6), washers (7), and two
clamps (8).
3.
Deleted.
NOTE
Direction of connector should be
noted and tagged for correct
reinstallation.
4.
Disconnect connector W11J7 (13) from
A2A1OJ1 on matrix switch assembly.
NOTE
On some models there may be eight
screws (Item 9).
5.
Remove four screws (9), lockwashers
(10), washers (11), and clamps (12)
and disconnect the following
connectors:
W11J2-J3 from Quad 2-3 (14)
W11J4-J5 from Quad 1-4 (15)
6.
Remove four screws (16), lockwashers
(17), and washers (18).
6.1. Move matrix switch assembly forward
4-6 inches.
7.
On rear panel of matrix switch assem-
bly, disconnect the following con-
nectors (19, typical):
W11P9 from MATRIX 1
W11P1O from MATRIX 2
W11P11 from MATRIX 3
W11P12 from MATRIX 4
W11P7 from MATRIX 5
W11P8 from MATRIX 6
W11P13 from MATRIX 7
W11P14 from MATRIX 8
W11P15 from MATRIX 9
W11P16 from MATRIX 10
W19P3 from MATRIX 11
W19P4 from MATRIX 12
W19P5 from MATRIX 13
W19P6 from MATRIX 14
W19P7 from MATRIX 15
Coax ground cable from MATRIX 16.
2-289
