TM 11-6625-3081-23
2-48. MULTIPROGRAMMER ASSEMBLY 2A2A6 REPLACEMENT (cont)
2-48
6.
Loosen four screws (14) and remove
lower panel (15) to allow removal of
circuit card connectors.
7.
Disconnect 11 circuit card assembly
(CCA) connectors (16) and remove from
rear of multiprogrammer.
CAUTION
This equipment contains parts and
assemblies sensitive to damage by
electrostatic discharge (ESD). Use
precautionary procedures when touch-
ing, removing or inserting circuit
card assemblies.
8. Comply with ESD procedures for CCAs
(para 2-21).
9.
Slide out two CCAs (17) to access
terminal boards.
10. Tag wires and remove five screws (18)
and wires (19) from each CCA terminal
board.
11. Slide two CCAs (17) into multipro-
grammer assembly.
12. Close access door (12).
13. Remove nut (20), lockwasher (21),
washer (22), and chain (23) from
multiprogrammer assembly.
14. Depress slide locks (24) and remove
multiprogrammer assembly.
INSTALLATION
15. Lift multiprogrammer assembly (4)
onto slides and push in until slide
locks (24) snap into place.
2-269
