TM 11-6625-3081-23
2-48.
MULTIPROGRAMMER ASSEMBLY 2A2A6 REPLACEMENT
2-48
INITIAL SETUP
Personnel Required
Tools
396 ATE Repairer
One assistant
Goggles
Rubber apron
Equipment Condition
Conductive wrist strap
Conductive work bench mat
Power removed (para 2-24.1)
Materials (appendix C)
Artist brush (Item 8)
Cheesecloth pad (Item 11)
Chemical film (Item 12)
Rubber gloves (Item 26)
Emery paper, 400 grit (Item 35)
Zinc chromate primer (Item 40)
Lacing tape (Item 44)
Trichlorotrifluoroethane (Item 48)
REMOVAL
1.
Remove four screws (1), lockwashers
(2), washers (3), and pull out multi-
programmer assembly (4).
2.
On rear panel of multiprogrammer
assembly, disconnect the following
cables:
W7P3 from DATA IN J1 (5)
W25P3 from DATA OUT J2 (6)
115 vac cord (7)
NOTE
If the multiprogrammer assembly is to
be replaced the ground lead will have
to be moved to the replacement assem-
bly.
If the same multiprogrammer is
installed use ground lead quick dis-
connect and omit steps 4, 25, 26,
and 27.
3.
Disconnect quick disconnect ground
lead (8).
4.
Remove screw (9), lockwasher (10),
washer (11), and ground lead (8).
5.
Open front access door (12) by turn-
ing screwlock (13) counterclockwise.
2-268
Change 2
