TM 1-6625-3081-30P SECTION I
6
(7) The USABLE ON CODE, when applicable (see paragraph 5, Special Information).
(8) In the Special Tools List section, the Basis of Issue (BOI) appears as the last line(s) in the
entry for each special tool, special TMDE, and other special support equipment. When density of
equipment supported exceeds density spread indicated in the basis of issue, the total authorization is
increased proportionately.
(9) The statement "END OF FIGURE" appears just below the last item description in Column 5
for a given figure in both Section II and Section III.
f.
QTY (Column (6)). The QTY (quantity per figure column) indicates the quantity of the item used
in the breakout shown on the illustration figure, which is prepared for a functional group, subfunctional
group, or an assembly. A "V" appearing in this column in lieu of a quantity, indicates that the quantity
is variable and the quantity may vary from application to application.
4. Explanation of Columns (Section IV).
a. NATIONAL STOCK NUMBER (NSN) INDEX.
(1) STOCK NUMBER column. This column lists the NSN by national item identification number
(NIIN) sequence. The NIIN consists of the last nine digits of the NSN
NSN
(i.e., 5305-01-674-1467). When using this column to locate an item, ignore the first
NIIN
four digits of the NSN. However, the complete NSN should be used when ordering items by stock
number.
(2) FIG. column. This column lists the number of the figure where the item is identified/located.
The figures are in numerical order in Section II and Section III.
(3) ITEM column. The item number identifies the item associated with the figure listed in the
adjacent FIG. column. This item is also identified by the NSN listed on the same line.
b. PART NUMBER INDEX. Part numbers in this index are listed by part number in ascending
alphanumeric sequence (i.e., vertical arrangement of letter and number combination which places the
first letter or digit of each group in order A through Z, followed by the numbers 0 through 9 and each
following letter or digit in like order).
(1) CAGEC column. The commercial and Government entity code is a 5-digit numeric code
used to identify the manufacturer, distributor, or Government agency, etc., that supplies the item.
(2) PART NUMBER column. Indicates the primary number used by the manufacturer
(individual, firm, corporation, or Government activity), which controls the design and characteristics of
the item by means of its engineering drawings, specifications standards, and inspection requirements
to identify an item or range of items.
(3) STOCK NUMBER column. This column lists the NSN for the associated part number and
manufacturer identified in the PART NUMBER and columns to the left.
(4) FIG. column. This column lists the number of the figure where the item is identified/located
in Section II and III.
