BASE ASSEMBLY REPAIR

ELECTRO-OPTICAL TEST BENCH SET INTERCONNECTION (cont)

TM-11-6625-3081-23-4 Electronic Equipment Test Facility TADS/PNVS Augmentation Equipment Manual
Page Navigation
25

TM 11-6625-3081-23 5-6. BASE ASSEMBLY REPAIR 5-6 This task covers replacement of: Para Item Para Item 1. Protective skirt 4. 2. Tubing Isolator assembly 5. Fitting 3. Valve assembly INITIAL SETUP References Tools and Special Tools Torque wrench 0-100 ft-lb Goggles Jack (2) Torque wrench 0-30 ft-lb 10 x 10 x 0.25 inch metal plate Materials (appendix C) Isopropyl alcohol (Item 4) Artist brush (Item 8) Acid brush (Item 9) Cheesecloth pad (Item 11) Hardwood block 4 x 4 x 8 inch (2) (Item 34) Pipe cleaners (Item 37) Sealing compound primer (Item 38) Sealing compound (Item 41) Teflon tape (Item 46) Personnel Required % 39B ATE Repairer One assistant TM 11-6625-3085-12 TM 11-6625-3085-30 Equipment Conditions E/O cable cover removed (TM 11-6625-3085-30) Power removed (para 2-24.1) Pneumatic system bled down (TM 11-6625-3085-12) Interconnection cables disconnected (para 5-5) FOLLOWUP Interconnection cables connected (para 5-5) E/O cable cover installed (TM 11-6625-3085-30) 1. PROTECTIVE SKIRT REPLACEMENT PNEUMATIC SYSTEM PRESSURE MUST BE BLED DOWN BEFORE PERFORMING MAINTE- NANCE ON BASE ASSEMBLY TO AVOID INJURING PERSONNEL OR DAMAGING EQUIPMENT. 5-8 Change 2

Privacy Statement
Press Release
Contact