TM 11-6625-3081-23
5-20.1.
CAMERA/BRACKET ASSEMBLY 2A1A2A1A1A15 REPLACEMENT
5-20.1
INITIAL SETUP
Materials (appendix C)
Cardboard (Item 10)
Lens paper (Item 36)
Masking tape (Item 45)
Personnel Required
396 ATE Repairer
Equipment Conditions
power removed (para 24.1)
Cabinet rear panel removed
(para 2-41)
Inner module upper rear access
plate removed (para 2-41)
FOLLOWUP
Inner module upper rear access
plate installation (para 2-41)
Cabinet rear panel installation
(para 2-41)
REMOVAL
CAUTI0N
Exercise special care when working
near optical surfaces.
Avoid touch-
ing or contaminating any optical
surface in lower portion of inner
module.
NOTE
The camera/bracket assembly and
camera head control unit 2A2A7A3 are
a matched set and must be replaced at
the same time.
Refer to para-
graph 2-51 for camera head control
unit 2A2A7A3 replacement procedures.
1.
Place cardboard over openings (1) to
protect mirrors (2) from falling
objects.
Cover exposed optics on
switching mirror (3) with lens paper
and secure with masking tape.
2.
Cut lacing tape securing camera/
bracket cable.
3.
Completely loosen two screws (4)
securing connector W33P1 (5) to A15J1
(6) and disconnect.
4.
Remove four screws (7) and remove
camera/bracket assembly (8).
INSTALLATION
5.
Install in reverse order of removal.
END OF TASK
5-100
Change 4
