TM 11-6625-3081-23
2-28. 488 CONTROLLER POWER SUPPLY ASSEMBLY 1A2 REPLACEMENT (cont)
2-28
NOTE
Chain (14) attached to 488 controller
power supply assembly has spring
tension applied when assembly is
open.
7.
Pull forward on front section of
cable carrier (15) and remove screw
(16), lockwasher (17), washer (18),
and chain (14).
Reposition cable
carrier (15).
WARNING
HEAVY OBJECT
EXCESSIVE STRAIN CAN CAUSE SERIOUS
INJURY.
DON’T: ATTEMPT TO LIFT OR CARRY
HEAVY OBJECTS ALONE.
DO: GET HELP FOR LIFTING OR CARRY-
ING OBJECTS WEIGHING MORE THAN 35
POUNDS.
IF YOU EXPERIENCE A SUDDEN PAIN
WHILE LIFTING OR DISCOMFORT AFTER
LIFTING, GET MEDICAL HELP AT ONCE.
8.
Using two persons, depress two slide
locks (19) and remove 488 controller
power supply assembly.
NOTE
If the 488 controller power supply
assembly is to be replaced, ground
lead will have to be moved to
replacement assembly as required
below.
If the same 488 controller
power supply assembly is to be
reinstalled, omit steps 9 thru 17
and proceed to step 18.
9. Remove screw (20), lockwasher (21),
two washers (22), and ground
lead (23).
2-193
