TM 11-6625-3081-23
2-22.
CLEANING (cont)
2-22
e.
Using a lens tissue moistened
with acetone and folded (four
folds), wipe mirror surface in
one direction with one wipe.
Use
new lens tissue moistened with
acetone folded for each
additional wipe.
f.
If an area or spot resists
cleaning using methyl alcohol and
acetone, place a few drops of
alconox in distilled water.
Saturate a small piece of lens
tissue slightly larger than the
spot or contaminated area in the
alconox solution and lay it over
spot or area for approximately
1 minute.
If the area or spot is
still not clean, place a few
drops of the alconox solution on
a cotton swab.
Use a dabbing
motion or slight wiping motion
with almost no pressure until
spot or area is clean.
Before
the alconox solution has dried,
repeat steps d and e above to
prevent leaving a stain of
alconox.
g.
Blow any remaining dust or lint
from mirror surfaces using
aerosol duster.
h.
Install cabinet rear panel
(para 2-41).
END OF TASK
Change 9
2-164.1