TM 11-6625-3081-23
2-17. OPERATOR INSTRUCTION MESSAGES
2-17
This section is an amplification of external cable and equipment connection and
manual intervention messages.
The messages (shown shaded) are presented as they
appear on the AN/USM-410 VDT, followed by expanded instructions.
Illustrations and
installation procedure references are used to clarify operator instructions.
The
information is presented by module input code.
NOTE
The numbers in parentheses are step
and illustration references and do
not appear on the AN/USM-410(V)2
VDT.
a. CALCST MESSAGES
(1) CHECK ALL FOUR BUS EXTENDERS
(HP 37203A) FOR:
ALL GREEN LIGHTS (LINE
ON) RED LIGHTS.
DEPRESS [YES] (F5) OR
[NO] (F6).
(2) IF A TIME OUT ERROR OCCURS
BEFORE THE SECOND TEST COMPLETES EITHER
THE HP1OOOL CONTROLLER OR THE CONTROL
INTERFACE CARD IS MALFUNCTIONING. CHECK
THE LIGHTS IN THE BACK OF THE HP1OOOL TO
SEE IF IT IS FUNCTIONING.
The operator checks extender assemblies
installation 1A9A1, 1A9A2, 2A2A8, and on
AN/USM-410.
The green line indicator
(1) should be on, the red DATA LOSS (2)
and DATA ERROR (3) indicators should be
off .
If all extender assemblies have
correct indications, press [YES] on the
AN/USM-410 VDT; if not, press [NO].
b. PLLBUS MESSAGES
PLLBUS contains no external cable
and equipment connect or manual inter-
vention messages.
c. MTRXSW MESSAGES
(1) A CONNECT MAJOR TEST ADAPTER
13083633-19 IN TEST ADAPTER PANEL
ASSEMBLY 2A2A4-J1.
Refer to paragraph 2-65 for installation
procedure.
(2) B INSTALL PERSONALITY CARD
1308231O-P1 SIDE IN MAJOR TEST ADAPTER
13083633-19 A7 SLOT.
Refer to paragraph 2-69 for the
procedure.
Change 16
2-100.1/(2-100.2 blank)
