TM 11-6625-3081-231-14.DESCRIPTION OF NIGHTSIDE TEST BENCH 2A3 (cont)1-14(3) The shutter assembly 2A3A1A2 is mounted on the front side of the nightsideoptical assembly adjacent to the sensor mount assembly 2A3A1A3. The shutter assemblyconsists of a shutter assembly housing, eight shutter vanes, cable assembly W7 (cablewith optical switch assembly attached), cable assembly W8 (cable with shutter solenoidattached) and electrical connector plate assembly.A dust cover is placed over theshutter assembly whenever a UUT is not installed.The purpose of the shutter assemblyis to remain open during UUT operation and closed for protection of the nightside testbench mirror assemblies when a UUT is not operating.(4) The sensor mount assembly 2A3A1A3 is a heavy, cast aluminum mount thatsupports and positions the night sensor assembly UUT for testing.It is mounted tothe front side of the nightside test bench and primarily consists of a mounting baseplate, handle assembly, sensor mount bracket assembly, and W1O cable assembly. Thehandle assembly locks the UUT to the sensor mount assembly. The W1O cable assemblycontains two optical switch assemblies Al and A2 that sense the lock and unlock condi-tion of the handle assembly.(5) The connector bracket assemblies (2A3A1A15 and 2A3A1A16) are two separatecable entry panels.These panels interface the cabling coming from cable entry panel2A3A4 and the internal cabling of the nightside optical assembly.(6) The secondary heat source assembly 2A3A1A17 is positioned inside the night-side optical assembly below the upper mirror assembly.It primarily consists of a1.5 inch heat source (heat source “C”), fold mirror housing assembly, air outlet ductassembly, and microcircuit and heat sink assembly.The latter assembly threads intothe plate of the heat source “C”.The microcircuit and heat sink assembly consist ofa cable assembly wired to a temperature sensor mounted inside a heat sink.Heatsource “C” contains a 1.5 inch square radiating surface controlled to an accuracy of1.O°C incremental steps.A fan is contained inside the heat source “C”.(7) Cable assemblies 2A3A1W5 and W6 contain all the connectors for interfacingthe assemblies contained in the nightside optical assembly. W5 contains connectorsP4, P5, and J1 thru J5.W6 contains one wired in temperature sensor, connectors J1thru J4, and P1 thru P15.1-91
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business