TM 11-6625-3081-23
1-12. DESCRIPTION OF DAYSIDE TEST BENCH 2A1 (cont)
1-12
g.
LASER POWER SUPPLY ASSEMBLY 2A1A6
The laser power supply assembly 2A1A6 consists of a high-voltage power supply
(HVPS) and an electronic box assembly 2A1A6A1.
The power supply assembly is located
between the inner module and the cabinet wall on the right side of the dayside test
bench.
The electronic box assembly contains a connector and two relays, K1 and K2,
that control the electrical output distribution of the HVPS. The high voltage outputs
are 600 and 1000 vdc.
A terminal board with one capacitor, one resistor and four
jumper lugs is located on the outside casing of the HVPS. The purpose of the laser
power supply assembly is to provide the required voltages to the laser system com-
ponents.
In addition, the assembly prevents these voltaqes from beinq distributed
when the laser system-operating condition is unsafe for personnel use:
Physical Dimensions:
Length 12.0 in
Width
8.0 in
Height
4.0 in
Change 4
1-51
