TM 11-4940-480-14
APPENDIX B
COMPONENTS OF END ITEM LIST
Section I INTRODUCTION
the illustration on which the item is shown.
B-1. Scope
(2) Item number. The number used to identify
This appendix lists integral components of and basic
item called out in the illustration.
issue items for the AN/TSM-126A to help you inven-
b. National Stock Number. Indicates the National
tory items required for safe and efficient operation.
stock number assigned to the item and which will be us-
ed for requisitioning.
B-2. General
c. Part Number. Indicates the primary number used
This Components of End Item List is divided into the
by the manufacturer, which controls the design and
following sections:
characteristics of the item by means of its engineering
a. Section II. Integral Components of the End Item.
drawings, specifications, standards, and inspection re-
These items, when assembled, comprise the AN/
quirements to identify an item or range of items.
TSM-127A and must accompany it whenever it is trans-
Following the part number, the Federal Supply Code
ferred or turned in. The illustrations will help you iden-
for Manufacturers (FSCM) is shown in parentheses.
tify these items.
d. Description. Indicates the Federal item name and,
b. Section III. Basic Issue Items. These are the
if required, a minimum description to identify the item.
minimum essential items required to place the AN/
e. Location. The physical location of each item
TSM-126A in operation, to operate it, and to perform
listed is given in this column. The lists are designed to
emergency repairs. Although shipped separately packed
inventory all items in one area of the major item before
they must accompany the AN/TSM-126A during
moving on to an adjacent area.
operation and whenever it is transferred between ac-
f. Usable on Code. Not applicable.
countable officers. The illustrations will assist you with
g. Quantity Required (Qty Reqd). This column lists
hard-to-identify items. This manual is your authority to
the quantity of each item required for a complete major
requisition replacement BII, based on TOE/MTOE
item.
authorization of the end item.
h. Quantity. This column is left blank for use during
an inventory. Under the Rcvd column, list the quantity
B-3. Explanation of Columns
you actually receive on your major item. The Date col-
a. Illustration. This column is divided as follows:
umns are for your use when you inventory the major
item at a later date; such as for shipment to another site.
(1) Figure number. Indicates the figure number of
(Next printed page is B-3)
B-1/(B-2 blank)
