TM 11-6625-3081-23
5-6.
BASE ASSEMBLY REPAIR (cont)
5-6
A 10 inch x 10 inch x 0.25 inch plate
must be used under each jack or van
floor may be damaged.
(5) Position a 10 inch x 10 inch
x 0.25 inch plate (10) next
to mounting plate (11) in
floor.
(6) Position jacks (12) under
edge of base assembly (6).
Be sure jacks are positioned
over mounting plates (11) in
floor and 10 inch x 10 inch
x 0.25 inch plate (10).
(7) position jack levers (13) UP
and insert jack handles (14)
into jacks (12).
DO NOT PLACE HANDS OR FEET UNDER BASE
WHILE USING JACK. INJURY COULD
RESULT.
Be sure jacks are raised at the same
time to avoid damage to equipment.
(8) Using an assistant, slowly
raise base no higher than
4 inches with jacks.
Operate jacks at same time.
(9) Place hardwood blocks (15)
under base, do not relieve
weight of base from jacks
(12).
Remove jack handles
from jacks.
5-23