TM 11-6625-3081-23
5-38. HEAT SOURCE TARGET ASSEMBLY 2A3A1A1 REPAIR (cont)
5-38
6. SOLENOID/CABLE ASSEMBLY W13
REPLACEMENT
REMOVAL
a.
b.
c.
Refer to 1 above and do steps a
through g to gain access to
solenoid.
Cut lacing tape as required to
remove solenoid and cable
assembly.
Disconnect cable W6P9 from
W13J1 (1).
CAUTION
Exercise special care when working
near optical surfaces.
Avoid touch-
ing or contaminating any optical
surface.
d. On solenoid (2), remove four
screws (3), washers (4), and
carefully remove solenoid.
INSTALLATION
e.
Install in reverse order of
removal.
END OF TASK
5-179