5-38. HEAT SOURCE TARGET ASSEMBLY 2A3A1A1 REPAIR (cont)
Position clutch (1) in mount and
place spacer (11), gear (10), and
clamp (6), onto clutch shaft.
Place coupling (14) onto front
shaft (15), aline couplings and
push clutch into place on mount
so couplings are properly mated.
Tighten setscrew (5) on
Install three screws (12) with
cleats (13) to secure clutch.
Aline holes in gear with spacer
Press gear (10) into place and
secure with three screws (9).
Install clamp (8) on drive gear.
Be sure clamp does not rub on
Tighten setscrew (7) on
Refer to 1 above and do steps q
END OF TASK