TM 11-6625-3081-23
2-57. MULTIPROGRAMMER EXTENDER ASSEMBLY 2A2A11 REPAIR
2-57
This task covers replacement
Para
Item
1.
Fuse
of:
Para
Item
2. Circuit card assembly (CCA)
INITIAL SETUP
Personnel Required
Tools
396 ATE Repairer
Conductive wrist strap
Equipment Condition
Conductive workbench mat
Power removed (para 2-24.1)
Materials (appendix C)
Electrostatic shielding bag (Item 7)
1. FUSE REPLACEMENT
NOTE
This procedure is used to replace
of three fuses in multiprogrammer
extender assembly.
any
REMOVAL
a.
b.
c.
Remove four screws (1), lockwash-
ers (2), washers (3), and pull
out multiprogrammer extender
assembly (4).
To remove fuse F1, disconnect AC
power cord (5),
slide fuse cover
(6) to left,
and pull FUSE PULL
tab (7).
Discard defective fuse
(8).
To remove fuse F2 or F3, locate
fuseholder cap (9) and remove
from rear panel by turning
counterclockwise.
Remove defec-
tive fuse (10).
Change 2
2-295