2-38.2 DISC/TAPE DRIVE 1A1O CASSETTE LOADING (cont)
On AC CONTROL panel (4), set CB1,
CB2, CB4, and CB5 to ON. Then set
CB3 (5) to ON.
On tape cartridge (6) set safe screw
(7) to SAFE.
During the following steps, the tape
cartridge is inserted into the tape
This starts an automatiac
tape conditioning sequence and
Insert tape cartridge (6) into tape
drive (8) until a click is heard.
BUSY indicator (9) is lit inter-
mittently during tape conditioning
sequence and self-test (approxi-
mately 1-2 minutes).
Upon completion of self-test, BUSY
Indicator (9) will go out and status
readout (10) will display a P.
Data stored on the cassette tape
will be copied onto the disc during
the following step. Loading process
takes approximately 30 to 45 min-
Toggle RESTORE TAPE to DISC switch
(11). When BUSY indicator (9)
begins to flicker, toggle RESTORE
TAPE to DISC switch (11) again.
Do not attempt to remove tape
cartridge until tape cartridge
unloading sequence is completed.
Press UNLOAD switch (12). BUSY
indicator (9) will be lit while tape